So I was downstairs in the basement this morning getting a fire going and I was having a hard time of it. Reason being is that this particular fireplace has a 90-degree bend in the flue which makes getting it going a bit challenging and takes some patience.
I wasn’t feeling very patient today and so I just “went for it” using kindling that was a bit too large and more than I should have started with, knowing full-well that I would probably smoke out the basement as a result. And, of course, I did have to open the doors to air the basement out while I was getting the fire going.
The thing is that I wondered why the smoke alarm nearest the fireplace didn’t go off because I was sure that it would have. And I knew for a fact that the batteries were good because I just recently replaced them a month or two ago.
Clearly, I wondered what was wrong, so I took the smoke alarm down and pressed the test button… nothing. I then opened the battery cover, removed the 9-volt, and my problem was obvious: I’d put the battery in backwards… literally 180-degrees the wrong way!
No doubt THAT smoke alarm was going to do me no good should I have ever needed it. Fortunately, I probably go overboard with my smoke alarms throughout the house, so I was likely covered by another–relatively nearby–smoke alarm but, regardless, I made an easily preventable mistake that I don’t believe I’d ever made before. And it was a mistake that could have cost lives.
Now I get to go check the rest of the smoke alarm batteries just to be sure they’re all installed correctly and, of course, I should be pressing the “test” button to ensure each of them works as expected… especially after I replace the batteries.